| Quellen | B. DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINERY
This declaration and translations thereof must be drawn up under the same conditions as the instructions (see
Annex 1, section 1.7.4.1(a) and (b)), and must be typewritten or else handwritten in capital letters.
The declaration of incorporation must contain the following particulars:
1. business name and full address of the manufacturer of the partly completed machinery and, where appropriate,
his authorised representative;
2. name and address of the person authorised to compile the relevant technical documentation, who must be established
in the Community;
3. description and identification of the partly completed machinery including generic denomination, function,
model, type, serial number and commercial name;
4. a sentence declaring which essential requirements of this Directive are applied and fulfilled and that the relevant
technical documentation is compiled in accordance with part B of Annex VII, and, where appropriate, a sentence
declaring the conformity of the partly completed machinery with other relevant Directives. These references
must be those of the texts published in the Official Journal of the European Union;
5. an undertaking to transmit, in response to a reasoned request by the national authorities, relevant information
on the partly completed machinery. This shall include the method of transmission and shall be without prejudice
to the intellectual property rights of the manufacturer of the partly completed machinery;
6. a statement that the partly completed machinery must not be put into service until the final machinery into
which it is to be incorporated has been declared in conformity with the provisions of this Directive, where
appropriate;
7. the place and date of the declaration;
8. the identity and signature of the person empowered to draw up the declaration on behalf of the manufacturer or
his authorised representative. |
|---|
